Waterproofing of Swimming Pool

Swimming pools have become very common in most luxurious residential buildings, hotels, resorts etc. The building and hotel owners usually demand for long lasting waterproofing solutions for their swimming pools. Architects, consultants and specifiers usually seek aesthetic as well as comprehensive waterproofing solutions for their swimming pools. Dura can provide complete solutions with a wide range of products.

  1. PROCEDURE FOR SWIMMING POOL WATERPROOFING
    1. TREATMENT BEFORE CONSTRUCTION OF RCC BASE SLAB OF TANK
      1. Repair/Smoothen the surface of PCC by 1:4 Cement Sand mortar.
      2. Apply 2 coats of DURAGARD (cement base polymer/acrylic modified highly flexible waterproof coating). Protect the coating against mechanical damage with 1:4 Cement Sand mortar (admixed with DURA1) of about 15 to 20 mm thickness, as shown in the figure.
    2. CONCRETING
      1. Add DURA 1, an integral water proofing compound confirming to IS:2645, shall be added to concrete to reduce permeability and increase the durability. The dosage of DURA 1 is 2% by weight of cement i.e. 1 kg for 50 kg bag of cement.
      2. DURAKRIT (hardening-cum-bonding agent) shall be used wherever the construction joints are coming. On the existing surface, Cement : Sand slurry shall be applied admixed with DURAKRIT in the ratio Cement : Sand : DURAKRIT mix :: 1:1 : 0.6.The green concrete is placed before the above slurry dries.
    3. SURFACE PREPARATION
      1. If honeycombs and voids are found in the retaining wall or slab, grouting has to be done through nozzles fixed at 1 m center-to-center with non-shrinking expansive grout, DURA EV.
      2. Make the surface free of oil, grease or any loosely adhering particles.
      3. Repair the substrate with rich mortar and DURAKRIT if there are any cracks (more than 1mm wide), pin holes, honeycombs, etc.
      4. Round all horizontal and vertical edges by making a mortar gola with rich mortar and DURAKRIT as per the specification of "Mortar Gola".
    4. TREATMENT AFTER CASTING RETAINING WALL & BASE SLAB
      1. Apply 2 coats of DURAGARD (cement based polymer/acrylic modified highly flexible waterproof coating) from positive side. The second coating must be provided at right angles to first coat once it is touch dry.
      2. The above treatment shall be provided from positive side.
      3. This shall be followed by one additional coating of DURAGARD reinforced with glass fibre mesh.
      4. Water leakage test in full supply level will be carried out as per IS 3370 part 1 for seven days as instructed.
      5. Protect the coating by laying glazed tiles/cement sand plaster admixed with DURA 1 @ 1 kg for 50 kg bag of cement.
  2. PROCEDURE FOR SWIMMING POOL TILING
    1. After completing the waterproofing operation, the tiles can be fixed on the pool walls/base using DURAFIX 1P/ DURAFIX 2P.
    2. The tile joints can be grouted using DURATILOFIL which is available in different colours to suit your needs.
    3. If needed any joints or fringes of swimming pools/ wet room decks can be sealed using DURASIL series.